Like, comment and track your own build in the Modfest app.
Project
Wiper Arm and Cowl Restore
1991 Nissan 300zx · Published 5mo ago
Repaint the wiper arms on my Z32 and use trim restore on the cowl.
3 parts
$526 steps
- 1
Remove nut holding on wiper arms
Remove the small cap covering the wiper arm nut with a flathead screwdriver. Then use a 14mm socket to remove the nut. Make sure to also mark where the wiper blades sit on the windshield so on reinstall you can line it back up.
- 2
Use battery terminal puller to lift the arms
The arms were held on really tightly from likely not being removed in 35 years. Use a battery terminal puller to lift the arm up.
Battery terminal puller - 3
Remove screws and clips holding in the cowl
There are lots of screws holding down the cowl. Make sure to get all of them, some are on top between the slits and others are inside facing towards the rear of the vehicle. The cowl is two pieces, remove the passenger side first by lifting up gently. Then get the driver side. Make sure to give it all a good cleaning while it's off.
- 4
Paint the wiper arms
I cleaned the wiper arms really well with dish soap to strip any oils. Then used a 3m stripping pad to really clean it and let it dry. I gave the arms 2 coats of paint.
Rustoleum Auto Enamel Matte Black - 5
Restore the cowl trim
I cleaned the cowl really well and let it fully dry. With it off the car, I used Cerakote trim pads to wipe the cowl down and restore the plastic.
- 6
Reinstall the cowl first, then wiper arms
Reinstall the cowl by first putting in the driver's side, then the passenger side piece. Do not tighten anything yet. Make sure it's all aligned the way you want and start putting the screws back in. For the wiper arms, the longer arm goes on the passenger side and the shorter on the driver's side. Slide them back onto the sprocket and align the blades with the tape we used earlier on. Once you're happy with the way it sits, tighten down the 14mm nut and add the cover caps back on.
1 comment

Tough!!